Skip to main content

Advanced Options

These are power-user settings that control timing, behavior, and troubleshooting options.

Timing Settings​

Startup Delay​

Pause for a set number of seconds before initializing. This prevents conflicts with other applications during system startup, particularly when multiple applications try to insert into the clipboard chain simultaneously.

Capture Delay​

Pause after you copy data to let the source application finish. Each further change to the clipboard restarts the pause, so a program that adds its data in steps is captured once. Default is 250ms (¼ second); 0 captures at once. Increase if you see "Can't open Clipboard" errors with:

  • Large, complex applications
  • Slow computers
  • Very large data types

Settle Time Between Captures​

Minimum wait time after capturing before accepting new items: a change that would be captured sooner is dropped. Default is 100ms. Decrease if you're missing copies during rapid succession (macros, automation). Be careful—too short may conflict with applications that don't release the clipboard quickly.

PowerPaste Delay​

How long after you paste, in milliseconds, PowerPaste waits before putting the next clip on the clipboard. Default is 250. Some programs read the clipboard a second time just after a paste; until the delay ends, they get the clip you just pasted, so PowerPaste doesn't skip one. If PowerPaste skips a clip in a program, increase it. If you paste faster than the delay, the same clip is pasted twice, so decrease it.

Behavior Settings​

ALT Key Required for Collection Tree DragDrop​

When enabled (default), you must press Alt to move collections via drag/drop, preventing accidental reorganization.

Pay Attention To Clipboard Viewer Ignore Flag​

Respects requests from clipboard-aware programs that want ClipMate to ignore their updates. Turn off to solve certain compatibility issues.

Enable Cached Database Writes​

For performance, ClipMate caches database updates. Turning off guarantees immediate disk writes but causes "disk chatter" and slight delays. Only disable if experiencing frequent crashes with data loss.

Buttons for Move/Copy to Collection Should Re-Use the Last Selected Target​

When enabled, the Move and Copy buttons default to the last collection you selected.

Reset/Clear Settings​

The tab has three buttons: Layout/Font, Application Profile and Everything. Each one asks you to confirm first, and none of them can be undone. Closing Options with Cancel doesn't undo them either.

Layout/Font​

Puts the ClipMate Classic window back to its default position and size, unpins it if it was tacked, and sets the editor font and font size back to their defaults. This happens the next time ClipMate starts, so restart ClipMate after using it. Other settings don't change, including the Explorer layout on the General tab.

Application Profile​

Clears every entry in the Application Profile, if it becomes corrupted or you want to start over. This happens at once, with no restart. ClipMate builds new entries as you copy from each program.

Everything​

Sets all settings back to their factory defaults. Use it if your settings have gone badly wrong.

  • The Application Profile is cleared and Start with Windows is turned off at once.
  • Everything else is reset the next time ClipMate starts, so restart ClipMate after using it. Any settings you change before restarting are reset too.

These are kept:

  • Your Databases, their clips and each Database's own settings
  • Saved searches
  • Paired Devices. Enable networking on the Devices tab is turned off, so turn it back on to connect to them again.

See Also​